Tuesday, October 4, 2011

Clipper Comb-Over-cutting technology


!±8± Clipper Comb-Over-cutting technology

The clipper-over-comb cutting technique is good for sides / sideburns and the bottom of the hair through the neck. Some general guidelines to consider:

* The hair must be dry because wet hair clumps and therefore will not be uniform cut off from the clipper blades. He made the Clipper-over-comb technique at the end of the haircut. If you cut too early to start cutting hair, the hair should be wet. But when have the outline and the top half of the finished productHead, should be the soil dry enough to cut with the Clippers.

* Keep the comb in the less dominant hand (left) and vertical lift sections of hair at an angle of 90 degrees (straight out) from the scalp.

* With the ship in the dominant hand (right), start at the bottom of the section of hair that sticks between the teeth of the comb. Move the stick your finger cut clippers, hair, comb your past.

* If you want to rejuvenate the hair with the bottom of theshorter and the tip of the cutting section are longer, you have to angle your comb. If you pick up the vertical sections of hair, you have a ridge near the end of the angle of the head and out the other end. Keep in a corner, make the most sense for the haircut makes you give.

* Keep cutting tools in vertical sections around the head. Work from the bottom of the hair, up, until you reach the bottom of the hair, the target already cut at the top of the head.

*With this technique, your comb is the most important role because it determines the amount of hair cut to go. Keep calm, how to cut the comb to avoid shocks.

* Use the hair you have already cut as a guide for how you act to keep your comb. Taking a few hairs, which already helps cut the uncut, along with a few hairs to see how you hold your comb for the next cut. Be careful with the first cut is because you have no manual for it. Be conservative withAs you cut the first cut. You can always go back and cut more if necessary.

With the clipper over comb cutting processes is a real lifesaver for hard to reach areas on the underside of the haircut. You can use the lower edges much shorter (and thus make your hair longer), if you construct your hair with a comb, rather than with your fingers.


Clipper Comb-Over-cutting technology

Sno Tek Snowblower Get It Now!




No comments:

Post a Comment


Twitter Facebook Flickr RSS



Français Deutsch Italiano Português
Español 日本語 한국의 中国简体。







Sponsor Links